View Single Post
  #11  
Old 11-07-2017, 03:42 PM
Tiberious's Avatar
Tiberious Tiberious is offline
Senior Member
 
Join Date: Dec 2007
Posts: 1,337
Tiberious has a brilliant futureTiberious has a brilliant futureTiberious has a brilliant futureTiberious has a brilliant futureTiberious has a brilliant futureTiberious has a brilliant futureTiberious has a brilliant futureTiberious has a brilliant futureTiberious has a brilliant futureTiberious has a brilliant futureTiberious has a brilliant future
Default Re: 1/72 Matchbox Lancaster

Got some work done today.

I made the jump seat for the cockpit. It's two pieces of styrene covered by Tamiya tape and paint. The slide bar for the seat and the swing arm for the back rest are thin wire.


Also redid the yoke, as the one from the kit barely resembled one.


More wire used.


IP glued in place, as well as the engineer's seat.


I forgot to take pics of the pilot's seat before putting it in, so here it is with everything else in place. I also fabbed a bench for the radioman.





I hope I got the seat height right.


And finally all closed up.



Now I need to go once more over the panel lines, then I can get back to the wings. And do the nacelles, which will need to have pane lines done as well, then sand off the scoops and closed exhaust. I have resin to replace those.

And drop the elevators.


Moving right along, and always more to do. Model on!
__________________
My stuff. Some even completed!

http://thome216.imgur.com/

http://s189.photobucket.com/albums/z156/Thome216/

Last edited by Tiberious; 11-07-2017 at 03:44 PM.
Reply With Quote